This item has been shown 643 times.
Click HERE for more information about this part.
is the ONLYAUTHORIZED
-STAGE 3 UNIT!-
HID is proud to present the stage IFuel performance fuel saving system
for your vehicle. The technology behind this product is mind-blowing!
Consisting of super high density 10800 gauss magnetic strength with
patented Neodymium (Rare Earth Magnet) technology, no other unit on the
market today will produce the same results as the Ifuel. The
technology in this Ifuel is used for cars, trucks, and motorcycles that
are trying to achieve maximum fuel efficency from thier engine.
Imagine getting more miles per tankful! The Ifuel is the ultimate
fuel saving device on the market today.
you'll receive with your Stage 3 IFuel Purchase:
-IFuel Performance Fuel Saving Device
-4 Screws to solidly affix device to fuel line
is the ONLYAUTHORIZED DEALERON
-STAGE 3 UNIT!-
present to you the iFuel Magnetic Field Fuel Ionizer. This patented
design bolts onto your incoming fuel line and works by filtering
irregularities and allowing for a cleaner fuel system. You may believe
that since you only purchase gas at a single gas station that you are
always buying the good stuff. However, depending on pricing, your
gas station buys from the same refineries at the lowest price that the
cheap chains do as well.
secret lies within the core of the Ionizer. The Power Performance
Ionizers are manufactured from only the finest quality Neodymium - Rare
Earth Magnets. Not typical magnets used in other applications. The
magnets interact specifically with molecules in gas to improve overall
combustion. This results in a more EFFICIENT & OPTIMAL burn. The
more efficient the fuel burns, the less that is required by the engine
to achieve optimal performance!
This translates into less carbon deposits in your engine and over the
course of ownership will result in hundreds of dollars of return on
your investment with a cleaner burning and more efficient drive train.
Please refer to the following chart based on EPA and iFuel findings
which clearly show a great improvement in the test subject 2005 Honda
Accord 4 cylinder with 78,000 miles on the Odometer.
you can see all the components in our kit are HIGH QUALITY and AUTHENTIC unlike the rest of these units listed on . Do not
get SCAMMED by their cheap made kits or knockoffs! Check out
in detail the quality and workmanship of our Stage 4 Mega Raizin. Notice the HIGH quality construction and
stage 4 condenser design of our Mega Raizin. Get that VOLT effect!
out the design of our ACTUAL product shown above. It is authentic ULIKE ALL THE REST on ! Look at our stage 3 design and
you will see just how much nicer made they look - don't take our word
for it, COMPARE for yourself!
NO ONE ELSE HAS
THIS DESIGN BECAUSE THEY SELL FAKES AND COPIES OF OUR KIT!
other kit on the market today will generate the same type of results as
this stage 3 unit. Other sellers are simply trying to imitate
and mimic our design and processes. They simply fall short on all key
areas. Our Stage 3 IFUEL is simply the best unit
currently in production - the pictures don't lie!
ASKED QUESTIONS (FAQ):
Q: What is an iFuel Ionizer?
A: The iFuel is a Fuel Ionizer with a built-in internal
Electromagnetic field generator that securely clamps to your fuel
delivery line. This device has been developed by US designs with
production in Japan, where they are known for their love of performance
and fuel mileage concerns. It is designed to SuperCharge incoming fuel
to your system at the atomic level by charging the particles and
aligning them to be all uniform with the use of the rarest Earth Magnet
- NEODYMIUM. The other cheap units you see on are using
worthless, common magnets.
Q: Is the Installation Simple?
A: The iFuel has all of its major components built-in. The only
installation you need to worry about is locating your incoming fuel
line (explained further below) and clamping the iFuel with its
supplied tools to the line.
Q: How quickly will I see a difference in performance and MPG?
A: In general, the duration of the iFuel working at maximum
efficiency will require about 2-3 tank fulls worth of ionization in
older vehicles and less in newer ones prior to supercharging your fuel
system and bringing it into the ideal ionization level required for
maximum fuel burning.
Q: What if I am not satisfied with the iFuel?
A: We strive for your total satisfaction, if you purchase an iFuel
and are not satisfied, we have one of the best return policies on
. Your happiness is our only concern.
HOW DOES IT WORK?
Untreated fuel molecules tend to clump together due to attraction
between molecules with charges of opposite polarities. This causes an
inefficient burn. As a result, your engine experiences loss of power,
lower gas mileage and lots of carbon build-up. The iFuel powerful
magnetic field causes these clumps of fuel molecules to be charged with
a single polarity, thus they repel each other making the fuel disperse
more efficiently causing more complete combustion and power production.
Turbomag will actually remove the existing carbon build-up in your
engine - this usually takes an average of 3 tanks full of gas, followed
by a dramatic increase in gas mileage and horsepower.
Installing the iFuel
1. Locate the fuel supply line under pressure feeding the engine from
the fuel tank. Vehicles with fuel injection engines normally have two
lines running parallel between the fuel tank and the engine, a supply
line and a return line. While the engine is running, feel the lines and
the colder one of the two will be the supply line you are connecting to,
2. Insert the nylon tie through the grooves that have the tie retainer
slot. This is to help hold the tie in position while applying the fuel
saver to the supply fuel line.
3. Simply place the fuel saver over the fuel supply line, at the
accessible location as close to the fuel injection system or carburetor
as possible. However do not install the iFuel in close proximity to the
alternator or any electromagnetic energy source. Installation on a
metal line has given the best performance. While we have had good
positive results on all materials, if you can, choose a metal fuel line
even if it is a connector before the carburetor etc. Do not install the
device on braided metal fuel lines however.
4. Align the iFuel halves so as the side grooves are alike. Complete
installation by wrapping the tie completely around the fuel saver
making sure the tie fits into the side grooves. Trim off the excess
tie. Check again whether the halves are vertically as well as
Due to the cleaning and removal process of the carbon/varnish deposits
inside the cylinders, the fuel consumption may temporarily increase
during the initial cleaning cycle. Mileage will stabilize after a short
time. Noticeable improvement may take up to three tanks of fuel and,
for optimum results to be achieved, please allow 1, 000 miles or 3 full
tanks of gas. A clean air filter and a can of carburetor or injector
cleaner mixed in the fuel will also help to give faster results and
regular upkeep of your vehicle's internals are still necessary.
Increased performance and smoother running will often also be noticed.
We ship to
most countries when the payment is confirmed in Paypal.
Please remember that shipping to HI, PR, or International
destinations can take as long as 4-6 weeks to receive. We
strive to make every effort to ship out our items asap.
Free shipping applies to US 48 states only. Any other ship to
destination will incur a shipping charge.
- Confirmed addresses only
card-Any Major Credit Card Payment Through PayPal
AND CONDITIONS OF SALE
purchasing or placing a offer, please read the following carefully!
How do I pay if I won
the sale or hit the BIN button?
you have won the sale simply follow the instructions provides
for placing payment.
Payment expected within 7 days after sale ends. Product availability
not guaranteed after 7 days.
PAYPAL payment is for shipping to your PayPal confirmed address only,
For NON U.S. Buyers , PAYPAL payment (in USD) is the ONLY payment
method will be accepted.
Insufficient amount orinsufficientinformation
will delay the process of order, please read the sale carefully.
How long will it take
for the item to ship and arrive?
the answer to this item depends. We strive to make every
effort to ensure that you receive your packages on time. On average it
will take between 4-11 business days for you to receive the package.
Sometimes it's much sooner, sometimes it's later.
What should you do
when you receive a wrong , defect, damage, or dissatisfy product ?
Since all our products are sold as brand
new, all damaged products are considered damage during transit. Please
inspect and hand-fit all items by the time it arrive. Customers MUST
contact us within 1 day after the date the package arrived via email
for all claims of shipment damage, defects, or missing parts. No claims
will be accepted after 7 days, NO EXCEPTIONS.
If the product you received is not what you
thought it was or the function as intended didn't meet you needs for
whatever reason, we will gladly replace it at no charge. However, it is
necessary that you provide a photo to show us the problem before we
issue a RMA number for you. We must first receive the product and
examine the defective item before an exchange, or refund is processed.
All return inquiries MUST obtain a Return
Merchandise Authorization (RMA) Number issued by us. The RMA number
must be clearly written down on the box/package. Item must be returned
and arrived within 14 days after RMA number is issued. Packages with
unauthorized returns or no RMA will be refused.
Buyer is responsible for returning the item
in its original condition (must have all original parts and packaging,
never to have been installed). Otherwise,a 40% restocking fee
will be charged.
Buyer is responsible for return shipping
costs under any circumstance. All shipping and handling fee will not be
Is there a money back
goal to provide 100% satisfaction to our customers. If you are not
satisfied with the product (you just don't like it or it is not what
you expected), you can ship back the item in the 100% original brand
new condition for the refund of theITEM PRICE
only.Buyer is responsible for the return shipping
fee.Item must be returned to our warehouse within 14 days
upon the item delivered date."FREE SHIPPING" items will be
charged 40% of item price for restocking fee. Item must has their
original packaging, no signs of being installed or mounted, used, cut
wires or scratches.Item must be original sale-able condition
(which is determined solely by XENONHID).Fees may apply if
item is determined as not original condition.
Why & What
happen if the buyer send us a email when he/she has a problem &
didn't get our reply ?
We will ONLY answer emails during our office
hours (Mon-Fri 8am - 4:00pm PST) except on holidays. All emails will be
replied in the order they were received the following business day.
Please check your SPAM/JUNK mail box if you don't see a
shipping, service, and warranty/return policy, please read our ""
Hours: Mon-Fri 8a.m.-4p.m. PT. We do not
answer emails, process orders or make shipments on weekends and on
strive to provide with the highest quality products and
service. Our commitment to
our most important goal. We only strive for 5 star ratings
and positive response!
Froo | Froo Cross Sell, Free Cross Sell, Cross promote, Marketing, listing Apps, Apps, Application