When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $77.27
dgunke Store STOCK#LCD1 (Pz)
battery latch for battery cover is missing -previously taped (tape residue) see photos
This item is pre-owned – it will work like new onceprogrammed to your vehicle
One (1)
Aftermarket remote keyless entry fob alarm LCD 2-way
Transmitter control clicker keyfob controller replacement pager
Functionsat 100% Tested & Guaranteed
Scytek / Astra Electronics
Part #: 2W-AM-LU
AM Frequency: 433 MHz
5 buttons
2-way LCD remote
( Alternate Spellings: two-way , two way , 2way )
Compatible with the following systems:
Astra-777
Galaxy 5000RS-2W
Galaxy 2000RS-2W
Astra 1000RS-2W
Astra 4000RS-2W
Galaxy 5000RS-2W-1
Galaxy 2000RS-2W-1
Astra 1000RS-2W-1
Astra 4000RS-2W-1
Programming Instructions:
BUTTON KEY:
(BUTTON 1) LEFT BUTTON ON FACE OF REMOTE
(BUTTON 2) RIGHT BUTTON ON FACE OF REMOTE
(BUTTON 3) BUTTON CLOSEST TO ANTENNA ON SIDE OF REMOTE
(BUTTON 4) MIDDLE BUTTON ON SIDE OF REMOTE
(BUTTON 5) BUTTON FURTHEST FROM ANTENNA ON SIDE OF REMOTE
The Astra’s 777 2-way LCD remote transmitter is offering increased range and confirmation of any activated feature.
Button 1 Arms and Locks* the system and when held for 5 seconds, activates the system’s Panic feature. Button 1 also locks the doors when the system is in Valet Mode.
Button 2 Disarms and Unlocks* the system. Pressing Button 2 again operates the Passenger Unlock feature (if installed). Button 2 also unlocks the doors when the system is in Valet Mode.
Button 3 Activates the Auxiliary 1 output normally used for trunk release (note trunk icon on button).
Button 4 Activates the Auxiliary 2 output.
Button 5 is the Confirmation, Programming and the Page Shift button. Quickly pressing button 5 will activate the Page 2 function. Pressing button 5 for 2 seconds activates the system’s confirmation feature which will then display the current status of the system (armed, disarmed, engine running, etc.).
Button 5 then Button 1 : Silently Arms and Locks* the system. Button 1 also locks the doors when the system is in Valet Mode.
Button 5 then Button 2: Silently Disarms and Unlocks* the system, also unlocks the doors when the system is in Valet Mode.
Adding/Replacing 2-way LCD Transmitters (2 LCD remotes maximum)
When adding an optional 2-way LCD transmitter to the system, follow these steps:
1. Turn on the ignition key On, Off, On, Off, On, Off, and back On. (Key On 4 times)
· The siren will chirp 4 times.
2. Press and hold the Override switch for 5 seconds.
· The siren will chirp 4 times.
· The LED will illuminate.
3. Press Button 1 on the first transmitter, then on the second transmitter.
· The siren will chirp once for each transmitter learned.
4. Turn off the ignition key.
5. The siren will chirp 3 times to indicate the system has exited programming mode.
LCD Transmitter Battery Replacement
Your Astra Remote Transmitter uses a 1.5 volt AAA alkaline battery, which will require replacement in time. Depending on the amount of use, the battery may last up to three months before it needs replacement. When the battery needs replacing, the system’s operating range will decrease, the LCD display will show only one of three bars in the battery icon, or the display and sounds may suddenly stop and start as the battery voltage drops below minimum. In order to change the battery, first slide the battery door locking pin to the side. Carefully slide the battery
cover downward until it is free. While replacing the battery make sure that the positive and negative terminals are positioned correctly, then carefully reassemble the transmitter case.
Setting the Time
The LCD display is equipped with a 12-hour clock that in addition to displaying the time, offers an alarm clock function as well as a remote activation timer.
To set the time:
1. Press and hold Buttons 2 and 3 for three seconds.
· The remote will beep two times and three bars will be shown indicating time set mode is entered.
2. Press Button 2 until the correct hour is displayed.
3. Press Button 3 until the desired minute is displayed. The button may be held down to scroll faster.
4. When the desired time is displayed, press Button 5 to store.
· The remote will beep 3 times to indicate the time has been set.
Setting The Alarm Clock
The alarm clock function can be set to play an alert melody at a specific time of day.
To set the alarm clock function:
1. Press and hold Buttons 2 and 3 until the remote beeps three times.
· The alarm clock bell and three bars will be shown indicating alarm clock set mode is entered.
2. Press Button 2 until the desired hour is displayed.
3. Press Button 3 until the desired minute is displayed. The button may be held down to scroll faster.
4. When the desired time is displayed, press Button 5 to store.
· The remote will beep 3 times to indicate the alarm clock has been set.
To disable the alarm clock function:
1. Press and hold Buttons 2 and 3 until the remote beeps three times.
· The alarm clock bell and three bars will be shown indicating alarm clock set mode is entered.
2. Press Button 1 to disable the alarm clock.
· The remote will beep 3 times to indicate the alarm clock has been disabled.
LCD Backlight
Transmitter Button 5 is used for confirmation, transmitter programming, as well as activation of
the LCD backlighting for use in the dark. Press button 5 to activate the LCD backlight.
System Confirmation
The 2-way transmitter\'s confirmation feature allows the current vehicle status to be displayed
at any time.
To display system status:
1. Press and hold Button 5 until the display shows CON.
· The transmitter will beep once.
2. Release Button 5.
· The transmitter will beep once.
· The icon representing the system’s current status will be displayed on the LCD panel.
Transmitter Programming
Pressing and holding transmitter button 5 will scroll through several transmitter programmable
options that may or may not be available depending on the model of system installed
DEG (degress) Not applicable on this model.
CHP Sets the siren confirmation chirps ON or OFF:
1. Press and hold Button 5 until the display shows CHP.
·The transmitter will beep 3 times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will show a siren if the chirps are enabled or \"off\" if the chirps are disabled.
SND Sound function allows disabling of the transmitter\'s confirmation tones.
To turn the transmitter confirmation tones on or off:
1. Press and hold Button 5 until the display shows SND.
· The transmitter will beep four times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will beep five times if enabled or vibrate and display “off” if the confirmation tones are disabled.
PSV Passive function allows the passive arming mode to be enabled oe disabled with the transmitter.
Note: This feature may not be available on all systems.
To enable or disable the passive arming mode:
1. Press and hold Button 5 until the display shows PSV.
· The transmitter will beep five times.
2. Release Button 5.
· The transmitter will beep once and the system will begin the passive arm mode
· The LCD panel will display “off” and vibrate twice if disabled.
VLT Valet mode function sets and resets the security system valet mode.
* This function is enabled only when the security system is disarmed
Set or reset the Valet mode:
1. Press and hold Button 6 until the display shows VLT.
· The transmitter will beep six times.
2. Release Button 5.
· The LCD panel will play a tone if the Valet mode was set “V\" will be displayed indicating
that the system is in Valet mode.
· The transmitter will beep twice if the Valet mode was reset. “V\" will turn off indicating that the security system is out of Valet mode.
MANUFACTURER CONTACT INFORMATION
ScyTek Electronics
11627 Cantara Street
North Hollywood, CA 91605
Program Remote To Your Vehicle
If you\'re notsure your vehicle can use thisremote, please ask questions or contact your local dealer first.
This remote needs to be programmed to your vehicle in orderfor it to work with your vehicle’s installed RKE (remote keyless entry )system:
See Above
Payment: We accept paymentvia PayPal or Credit Card. Please contact us via eBay messages for anyquestions concerning payments. Payment is expected within 5 days.
PASALES TAX: As per the State ofPA Franchise Board we must collect sales tax from PA Residents for any purchasemade from our store.
Contact/Email: Due to scams etc, we DONOT respond to emails. We only read/respond to EBAY MESSAGES. Messages &Best Offers are checked throughout the day & we typically respond 7 days aweek. Please contact us with questions via eBay messages (keyless4u).
100% Guarantee Remote Shipping / ReturnPolicy
Shipping & Handling
Combined Shipping & Handling Discount (multiple itempurchase discount):
S&H discount = the price of the1ST remote’s S&H + 1.99 each additional remote’sS&H
ShippedFrom: Pennsylvania, USA
ShippingMethod: USPS mail service
USAShipment Options:
◊ USPS 1STclass mail service
◊ USPSPriority class mail service
◊ USPSEXPRESS class mail service
CanadianShipment Options:
◊ USPS 1STclass mail service
◊ USPSPriority class mail service
◊ USPSExpress class mail service
Worldwide(Outside of USA & Canada) ShipmentOptions:
◊ USPSPriority class mail service
◊ USPSExpress class mail service
Warranty/Returns:
1.Wehave a 30 day return policy.
2.Allreturns for replacements and refund need an RMA #.
3.Pleasecontact us before returning items so we can give you theRMA # and theproper return address.
4.Norefunds / replacements will be granted without an RMA#
We ensure properworking condition of all previously used or new remotes through a serious oftests performed with the Santronics Testing device. Each button is tested forfunctionality prior to shipment and then logged.
Please Note: Each remote and circuit board is UV id’d prior toshipment – All returns receive a UV IDinspection to verify originality of remote sent prior to refund or replacement.
Does thiskeyless remote entry come with a battery?
Yes. It will have a working battery installed.
Battery Condition:
A. All remotes sold on Keyless4u include workingbatteries.
B. Installed batteries are not tested forbattery life- they are simply working.
Some are new and some are used.
Your vehiclewill be installed with one of the following keyless entry systems:
a. Standard Keyless Remote Packages:Installed at time of manufacture.
b. OptionalKeyless Remote Packages: Installed by a dealer.
c. Aftermarket Keyless Remote Packages:Installed by previous owner or a car/audio shop.
d. No remote keylessentry system at all.
The aboveinformation can change which remote you need
for your installed remote keyless system.
--- Thank You!
.
.
.
.
.
.
.
.
.
.
.
Powered by eBay Turbo Lister
The free listing tool. List your items fast and easy and manage your active items.
.
.
.
.
.
.
.