When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $84.88
Hurst INDY chrome shifter stick:
- Brand new bulk part (not available in retail packaging)
- 15.0\" tall, curving ~1\" forward then rearward to end 1.3\" behind center
- Good alternative to # 0060 and right between # 6900 & # 4331
- 3/8\"-24 knob threads (NOTE this is different from other Hurst sticks!)
- Knob NOT included (various options available separately)
- Forged mild steel - case-hardened for toughness, chrome-plated for beauty
- Modification is difficult & could compromise material integrity
- \"INDY H\" stamped into both sides
- No mating serrations (bolt to smooth side of stub)
- Great for custom installations - measure before you buy!
- Mounts via 3/8\" bolt holes spaced 7/8\" apart - fits any aftermarket Hurst stub
- Many off-brand shifters use 8mm stick bolts - request special adapter bolts
- Mix parts carefully as proper leverage ratio (throw length) requires matching stick length to stub fulcrum height - see my swap bases for fulcrum options
IF YOU ARE DOING A SWAP - application info is irrelevant once transmission is changed - sit in vehicle with tape measure while studying Hurst catalog - stick section.
This stick is used by Hurst Indy SSA kit # 5010002 AND Indy truck kit # 5010016 generic 3 speed floor conversion kits for ~\'60s era cars & trucks. In the SSA kit the fulcrum pin goes through the upper hole and the lower hole gets a pin that controls gate selection (there is no stub), leaving only 13\" above the fulcrum. In the truck kit (since 1995), the stick bolts on to a stub 2.5\" above the fulcrum, putting the knob 17.5\" above the fulcrum. In this way, the same stick works for car and truck. Truck kits produced before 1995 used a longer stick without a stub just like the cars but slowing sales required consolidation to one stick. These details aren\'t relevant to conversion purposes but help explain its features. YES this stick will bolt onto any Core / Hurst swap base - but you still need to measure and study to make sure it works for you. The mounting bolt pattern is the same as any regular Hurst stick. The differences are that it has a third hole above the mount that is not used, there are no mating serrations, it says INDY on the sides, and most importantly it has 3/8\"-24 knob threads - NOT 3/8\"-16!
SEE MY OTHER LISTINGS FOR SHIFTERS, STICKS, KNOBS, T-HANDLES, & \"HURST EQUIPPED\" EMBLEMS!