When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $59.47
Semi Sealed Beam Headlight 7" Multi Surface Reflector Clear Lens H4 - Blue LED Halo - SingleCustom MustangsProduct Details
You are buying a single 7ā€¯ Round Semi Sealed LED Halo headlight with Clear Glass Lens.
You've seen other LED Halos, some with 2 sets of LED's at 12 o'clock and 6 o'clock positions, these cheapies are usually identified by the plastic/composite housing, and the glass lens. We try not to sell those.
You may have seen our other lights, they are a little more expensive, but have LED's at 4 points, 12 o'clock, 3 o'clock, 6 o'clock and 9 o'clock. These are better than the plastic lights, with their metal housing, and brighter LED's, and were our favourites... Until now.
These lights have an amazing36 high powered SMD LED's around the perimeter! These are nearly as bright as good DRL's! (and probably brighter than some crappy DRL's).
Not only do they have9 times more LED's than our competitors, but they have a metal housing, inner reflector, great dust boot and even rubber grommets where the halo wires pass through the housing!
The 2 wires can be connected to any power source, ie: your parkers, ignition (constantly on when car is on) or to a separate switch, it's your choice.
These lights take a H4 globe which is not supplied, however they are a very popular globe and are readily available from any automotive parts supplier, or can be supplied for a small extra cost.
The H4 globes have 3 pins on the rear the same as sealed beam lights. Which means these lights are a direct replacement for sealed beam lights along with a H4 globe to plug straight into your vehicle.
NO GLOBES ARE PROVIDED WITH THESE LIGHTS -However, we can supply them at an additional charge.
These lights are simple and easy to install.
- Firstly remove the ring around the lights already in the vehicle by undoing the 3 screws.
- Gently tap out the old light and unplug the wires from the back from the globe.
- Carefully insert the newly acquired H4 globe into the New light lenses. Without touching the H4 globe (Never touch the Globe with your fingers)
- Put the rubber boot over the globe then attached the wires to the plug.
- Insert new lenses into vehicle and re-secure with the ring you removed earlier with the 3 screws.
- Enjoy your nice new brighter and clearer lights!!