When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $439.00
Short throw shifter kit for OE replacement on 5 speed manual trans in:
- 1998-2003 Chevrolet S-10 / GMC Sonoma - 4.3L V6 only
- 1998-2005 Chevrolet Blazer / GMC Jimmy - (4.3L V6 std)
- 1998-2000 Isuzu Hombre - 4.3L V6 only
ONLY FITS NV3500 gearbox specific to these models - GM RPO M50
- Does NOT FIT 2.2L 4 cyl, older models (different sticks), full-size (C/K or Silverado) trucks, or any other vehicle
- Base configured for transmission receptacle height of 7/8\" as original to these models
- Replaces GM #12382854 ; 26588
- IF your transmission has been serviced, it MAY REQUIRE A DIFFERENT BASE. If you install the wrong one it will not work properly and could cause damage. To confirm height, remove shifter base and measure transmission as shown in last pic
- Knob height ~ same as stock (stick #8009)
- Also available w/ ~2\" shorter knob height (stick #8550) - go to website
- IF YOU HAVE A 2\"+ BODY LIFT: a taller stub or extension bracket may be needed
Kit includes chrome stick, classic knob, base assembly w/ lower pivot cup, mounting hardware, dust cover boot, floor boot adapter grommet, and installation instructions. This kit includes a boot grommet to adapt the stock console boot; no aftermarket boot necessary or recommended however a SuperBoot is optional (sold separately). Throw is reduced by ~ 30%. Compare to discontinued Hurst #3910113
The base is built by Core Shifters using proven components inside a custom housing:
- High-strength billet steel gear selector stub
- Hardened steel cross-pin & stainless steel fulcrum pivot ring
- Self-centering cross-gate bias springs with heat treated spring seats
- Glass-reinforced polyamide fulcrum socket with steel wear clips
- Rubber oil control seal with steel retaining ring
- Extruded aluminum housing with Spirolox steel support ring
- CNC-machined billet aluminum base
- Laser-cut steel lid