When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $52.96
The part number is 98-1308
This listing is for a set of 4 NEW BLEM BABY MOONS.
The BABY MOONS in this listing are called BLEMS.That means there is a minor blemish. There are minor scratches, a small discolored area, or a very small dent. If there is a dent it has to be so small that you can barley tell it is there.
I even inspect the blems.
I only offer what would be good enough for my family if we were buying them.
These baby moons are a great price for new ones with minor blemishes.
The price reflects the blemishes.
IMPORTANT----------------PLEASE BE AWARE THERE ARE OTHER SIZES OF BABY MOONS. BE SURE YOU MEASURE TO ENSURE YOU A CORRECT FIT.A COUPLE MINUTES SPENTREADING THE INFORMATION BELOW AND MEASURING WILL SAVE FRUSTRATION AND MONEYON FREIGHT BACK AND FORTH.
MY PICTURE HAS LOTS OF REFLECTIONS. THEY ARE ONLY REFLECTIONS AND NOT IMPERFECTS.
WE HAD TO GO OUTSIDE TO TRY AND GET A PICTURE WITHOUT SO MANY REFLECTIONS. YOU ARE SEEING THE SKY IN TEXAS!
This is a BLEM NEW set of 4, chrome plated baby moon center caps that will fit many OLDER FORD CAR 4 LUG factory painted wheels.
These are aftermarket baby moon hub caps, which are made to fit wheels that have the nubs on the outside part of the center of 4 LUG CAR FORD FACTORY WHEELS.
PLEASE MEASURE! THERE ARE DIFFERENT SIZES OF BABY MOONS.
1. THE OUTSIDE DIAMETER IS 9.62 INCHES.
2. THE FLANGE DIAMETER IS 9.23 INCHES
3. THE MOONS ARE MADE OF CHROME PLATED METAL
4. THE LIP AROUND THE OUTSIDE OF THE BABY MOON IS ABOUT .80 INCHES.
5. THE HEIGHT IS ABOUT 2 1/2 INCHES MEASURED FROM THE BACK SIDE IN THE MIDDLE OF THE BABY MOON.
THIS SIZE IS UNIQUE TO FORD CAR FACTORY STEEL PAINTED WHEELS ONLY WITH A 4 LUG BOLT PATTERN.
HOW TO MEASURE THE FLANGE DIAMETER 9.23 INCHES ---YOU CAN MEASURE YOUR WHEEL FOR THE SIZE BY STARTING UNDER ONE NUB AND THEN GOING STRAIGHT ACROSS TO THE UNDERSIDE OF THE OPPOSITE NUB. YOU MUST MEASURE UNDER THE NUB AND NOT ON THE TOP SIDE. THEY ARE MADE OF CHROME PLATED METAL AND THERE IS A LIP ON THE BACK OF THE CAP WHICH CLIPS OVER THE NUBS FOUND IN THE CENTER OF THE WHEEL.
These caps cover up the lug nuts and they snap in from the front of the wheel. PLEASE MEASURE YOUR WHEEL CENTER AND MAKE SURE THIS IS THE SIZE THAT YOU NEED.
AGAIN NOTE THAT THIS IS AN OUTSIDE SNAP STYLE BABY MOON WHERE THE NUBS ARE LOCATED ON THE OUTSIDE CENTER OF THE WHEEL. I ALSO HAVE OTHER SIZES AVAILABLE AS WELL AS INSIDE SNAP BABY MOONS.
PLEASE READ BELOW FOR INSTALLATION!
WHEN INSTALLING THESE BABY MOONS, CLIP THE BABY MOON OVER A COUPLE OF THE NUBS IN THE CENTER OF THE WHEEL AND THEN WITH THE PALM OF YOUR HAND, GENTLY POP IT ON KEEPING THE PALM OF YOUR HAND ON THE OUTSIDE EDGE OF THE BABY MOON. THE BABY MOON WILL FIT TIGHT. NEVER PUSH IN THE CENTER AS METAL CAN BE BENT WITH A HARD KNOCK. THEY WILL POP ON AS DESCRIBED ABOVE.
THANKS FOR LOOKING.