This item has been shown 185 times.
Click HERE for more information about this part.
Please read entire ad carefully before purchasing!
NEW Volo FS3
OBD-II Fuel Saver Chip
Fiat Stilo 2005*
*Programmed for all factory engine options produced for this model in 2005.
The fastest, safest, & easiest way to increase fuel economy through ECU tuning.No loss in power!
Compatible with factory equipped Turbo/Supercharger and Diesel Engines
Based on the VP12, our most powerful Dynamic Soft-Flasher
Installs in minutes without opening the hood, no skill required
Compare to Jet Chip DST ($199) or Venom 400 ($349)
Will not void your warranty - 100% safe for your engine
Completely reversible, makes no permanent changes
90 day Satisfaction Guaranteed or your money back
Free Firmware Updates and Vehicle Reconfigurations for LIFE!*
*Available on our website. Standard shipping fees apply.
CAN, PWM, VPW, ISO
20MHz CMOS MCU
-40ï¿½C to 85ï¿½C
Installation Video - HD 5:22
How it Works:
The FS3 uses an exclusive process of Dynamic Soft-Flashing not available anywhere else. Each FS3 comes programmed with a set of EPROM addresses that directly affect fuel efficiency. When the ECU attempts to read one of these addresses, the FS3 patches the factory value with one from its on-board highly tuned map.
The FS3 is our most powerful Dynamic Soft-Flasher. Operating at 20MHz with plenty of Flash Memory, the FS3's 8-Bit CMOS microprocessor offers extended compatibility along with faster patching for safer, higher, and more consistent gains.
BEWARE other "Performance Chips" that connect to the IAT...
How IAT "chips" damage your vehicle:
The majority of so-called "Performance Chips" on are simple 1ï¿½ resistors, often presented in a fancy box, sometimes with a switch or knob hanging off one side. They ALWAYS connect to the IAT and disable its functionality, and WILL damage your engine. The fact that these chips claim gains of 50, 80, even up to 100HP (better than most forced induction conversions) for a mere $20 or so is simply absurd. We at Volo wanted to take the chance to explain why these are bad for your vehicle...
While you may notice your car drives differently without a functioning IAT, it is certainly NOT running better.
The IAT is an important sensor in your vehicle's fuel injection system. The ECU depends on it to measure the temperature of air coming into the engine. Cold air requires more fuel for a richer mixture due to the density, and because fuel does not vaporize well in cold air. The IAT "chip" is simply a resistor with a value equal to that of the IAT's output on a cold day. This fools the ECU into delivering excess fuel during normal driving. Now there is not enough air for an ideal 14.7:1 stoichometric air/fuel ratio. The engine runs rich, fuel goes unburned, and is passed through the exhaust. Not only does this drastically decrease gas mileage (contrary to claims of improved economy), it also causes the catalytic converter to operate less efficiently resulting in excess CO2 and an emissions fail. When driven for extended periods, permanent damage to the O2 sensor ($150) and catalytic converter ($400+) will occur. On newer vehicles, disabling the IAT with a resistor will trigger a Check Engine light as well as void most warranties. The IAT is there for a reason!Please use your best judgement when purchasing accessories for your vehicle. If you are considering purchasing a chip that you are unsure of, please contact us and we'd be happy to look it over.
Will the FS3 void my warranty?
Unlike ECU ROM chip replacements or permanent ECU flashing, the FS3 makes no changes to the ROM itself and does not require opening the ECU. It will not void your factory warranty.
Will the FS3 increase or decrease horsepower/torque?
The FS3 will cause no loss in power. It has been designed for consistant fuel savings. For a signifigant power increase along with moderate fuel savings, check out our VP12.
Will it be compatible with my current modifications?
Modifications that do not alter factory compression ratio or stroke are 100% compatible with the FS3. Many upgrades such as aftermarket intake and exhaust will compliment the FS3's performance. The device will automatically compensate for your modifications during its initial calibration.
What if I plan to add modifications later?
Anytime you add a modification that affects engine performance, you must reset the device and allow to recalibrate. During calibration the Volo Chip will extrapolate new target value sets based on your vehicle's current performance characteristics, fine tuning engine output.
Why is it so much cheaper than other ECU mods?
The FS3 was purpose built and is not capable of more advanced features like altering rev limit or disabling the top speed governor.
How much can I expect to gain?
Gains vary depending on many factors. We've created a simple tool to help estimate what you can expect in your Fiat Stilo. If you are having trouble viewing the Gain Calculator below, please visit our website.
Installation time : 10-20 minutesTools required : Screwdriver, PliersThe FS3 does NOT include an OBD-II connector, but connects directly to the OBD-II port's data input/output via four tap-in connectors. OBD-II scantools will not interfere with operation.You must press the RESET button and allow the engine to idle 1-3 minutes to calibrate the device after first installation or after modifications. Frequent installation and removal of the device is not recommended.
View full installation instructions here...
FREE 2-3 day shipping Worldwide!Orders inside the USA are sent via USPS Priority Mail.International orders are sent DHL Express.IMPORTANT: Your item will be shipped to the address specified during checkout. If this is not where you want the item shipped, you must add the address to your account. Orders are sent immediately after payment is received. We cannot accommodate address change requests by email.Tracking information is available by clicking the link next to your payment in your PayPal Account.
This product comes with a 90 day satisfaction guarantee!Please contact us before leaving NEUTRAL or NEGATIVE response. Doing so will not expedite refunds or communication, and solves nothing. Keep in mind that a successful transaction and your complete satisfaction is our #1 goal!In the rare event you don't notice a difference immediately, please reset the chip as indicated in the instructions and try again. Depending on the vehicle, it may take up to 120 miles of driving before some ECUs will accept the FS3's patched values. This safety feature prevents an ECU hiccup from impairing the entire system.
If you've tried everything and still don't notice a difference, return the chip and we'll be glad to provide a full refund of the purchase price.
Similar 1/4 mile timeslips to browse:
1957 Chevrolet Bel Air pro mod: 6.520 @ 218.330
Bruce Micetich, Engine: 526 ci alan johnson pontiac, Supercharger: 14-71 SSI F rotor Tires: mickey thompson
1957 Chevrolet Bel Air Pro Mod: 6.750 @ 211.000
Dave Jackson, Engine: 526 AJ, Supercharger: 1471 Hi Helix Tires: 34.5
1960 Chevrolet Bel Air : 7.951 @ 182.930
Mike Casella, Engine: 707 Donavan, Tires: Hoosier
1955 Chevrolet Bel Air 210: 8.054 @ 167.550
Tim Harper, Engine: 522 BBC, Supercharger: Procharger F-2 Tires: Hoosier Quick Time Pro 31X18.50
1960 Chevrolet Bel Air 2dr Sedan: 8.134 @ 169.830
Mike Casella, Engine: 707 Donavan, Tires: M/T 10.5W
1956 Chevrolet Bel Air hardtop: 9.320 @ 145.000
Berny Corscadden, Engine: Big Block, Supercharger: no Turbos: no Tires: Hoosier
1955 Chevrolet Bel Air : 9.780 @ 139.600
1960 Chevrolet Bel Air 2 dr: 9.885 @ 133.490
Mike, Engine: 406, Tires: 33X18.5 ET Street
1963 Chevrolet Bel Air Sedan: 9.950 @ 146.500
Matt Pereira, Engine: 283, Supercharger: None Turbos: None Tires: Front: 27 Dia by 7 wide: Rear29 dia by 10 wide
1955 Chevrolet Bel Air : 10.700 @ 127.000
Tom Shideler, Engine: 454, Tires: hoosier
1962 Chevrolet Bel Air : 10.920 @ 121.820
Travis Horton, Engine: Real 409,
1955 Chevrolet Bel Air 150 2dr post: 11.176 @ 117.890
Dustin Knowles, Engine: 468 BBC, Supercharger: none Turbos: none Tires: goodyear racing slicks
1957 Chevrolet Bel Air 2-door Post: 11.385 @ 118.660
Doug Mill, Engine: 408ci small block - Built by Dale Green at DG Machine, Auburn, WA, Tires: M/T ET Streets - 11.50x15
1956 Chevrolet Bel Air sports sedan: 11.600 @ 120.200
sean, Engine: sbc 406, Tires: m/t et street
1955 Chevrolet Bel Air 2 DR SEDAN: 11.911 @ 113.250
Bob Evans, Engine: 383, Supercharger: no Turbos: no Tires: MT P235/60-15 DRAG RADIALS
1974 Nissan 240z 260z turbo: 12.246 @ 115.830
Jeff, Engine: 2.8, Turbos: 62-1 BB Tires: 215-60-14 BFG DR
1974 Nissan 240z : 12.993 @ 108.150
Jeff, Engine: L28et, Turbos: turbonetics 62-1 stage 5 BB Tires: bfg 215-60-14
1971 Nissan 240z : 13.020 @ 110.970
Selvyn Scott, Engine: 81 280ZX Turbo, Turbos: Stock T3 Tires: BFG 245/50ZR15
1957 Chevrolet Bel Air : 13.100 @ 0.000
Stephen Aldridge, Engine: 454ci Chev, Tires: 205 on Front 295 on Back
2005 Nissan Armada SE 2WD: 14.923 @ 90.840