This item has been shown 0 times.
Click HERE for more information about this part.
2000-02 MITSUBISHI MONTERO SPORT BRUSHED ALUMINUM FINISH DASH KIT
Application: USE THE INSTRUCTIONS IN THE KIT
Pieces in Kit: 24
*NOTE: This Kit is For aLeft Drive Car/Truck Only.
TOOLS REQUIRED, Utility Knife, Paper Towels, Cotton Swabs, Hair Dryer, Rubber Gloves
Ideal Installation Temperature: 70-85F
1) Dry Fit all Components In Order to Get a Visual Perspective on Part Placement Before Installation
2) Install Smallest Components First in Order To Get Familiar Before Attempting Larger More Difficult Pieces.
These are Heritage Dash Kits, Made by Wood view Automotive Trim. Precision Laser Cut, Easy to Install, With Step Step Instructions Listed Below. We make our kits from Simulated Materials.
We Have a Large Amount of Pictures on File But Do Not Have All the Correct Interior Shots of the Product Installed. You Will See the Parts Kit Opened and a Shot of the Actual Kit that is Shipped.
If The Kits Have Been Install They ARE NOT & Cleaning:
Using Isopropyl Alcohol, Thoroughly Clean the Surface Areas That are to Be Covered by The Dash Components. The Dash Should Be Free of Lint or Contaminants Before Installation. Used Or Pre-Owned Vehicles that Have Had Silicon Based Vinyl Treatments such as "Armour-All" or "Formula 2000" Need Special Care. The Adhesive Will Not Stick to Any Surface That has Any of the Residue Remaining. In These Cases, a Stronger Cleaner May Be Necessary. If the Dash is Dull in Appearance, And You Know Silicon Residue Can Be Felt on Your Fingers, The Dash Should be Fine. You Can Test the Surface Using Masking Tape to See if It Adheres.
Applying the Adhesive Promoter:
Open The Packet of Adhesive Promoter in a Dish. Dip a Cotton Swab Into the Adhesive Promoter and Carefully Apply the Product Only to the Surface Area that Are to Covered by the Trim Pieces.
WARNING Adhesive Promoter is Highly Corrosive and Will Permanently Discolor any Part of the Vehicle That it Comes In Contact With. We Highly Recommend the Use of Rubber Gloves When Applying the Product to Protect Your Skin. Please Use Only in a Well Ventilated Area To Avoid Inhaling the Fumes.
An Adhesive Promoter Pen is Available at a Extra Charge from the Manufactures. Each Pen Lasts for 5-10 Dash Installations.
Now You are Ready to Apply the Interior Package. First Using Your Utility Knife Catch the Corner of the Red Liner of the 3M Adhesive and Remove It. Be Careful to Avoid Making Contact With the Adhesive Surface so as Not to Contaminate the Tape. Once The Liner is Removed, Carefully Install the Part "Left To Right" in Order To Avoid Center Buckling. Once The Part is in Place, Gently Press Down With Your Fingers to Ensure that the Product has Made Good Contact. In Bending Situations or In Cold Climate Installations, Use the Hair Dryer to Soften the Parts Before Bending. It Will Not Only Avoid Breakage, But Will Make the Tape More "Tacky" for a Better Contact.
WARNING: The 3M 4229P Tape Fully Cures over a 72 Hour Period. Please Avoid Tampering with the Kit During This Time. If You See a Piece Lifting, Gently Press it Down Into Place.
Cleaning and Care:
Clean Your Dash Kit Using Water or Window Cleaner. Avoid Using Vinyl Treatments That May Effect Adhesion Over Time.
We use Paypal as our principal payment vendor.
We ship most items on UPS ground to the lower 48 USA States, USPS for every where else.
We would like to have payment done at the time of buying the item, we have listed many ways to pay for the item.
Please read before leaving response and DSR's.
WE STRIVE FOR 5 STAR BUYER SATISFACTION! Contact us if a problem arises before
Business hours: Monday - Friday 7:00am - 5:00pm EST. Sat-Sunday Closed
If for any reason you are unsatisfied or feel unable to leave a full (5)five
stars for all categories, please contact us BEFORE leaving the response.
If every one of our buyers was to give us a (4) four star rating we would
be suspended. (4) four star rating on means Bad service. This suspension
on starts at (4.3) four point three stars out of (5) five stars for
sellers. This is so important to the ongoing success of our business and
the more successful we are, the better we will be able to support you in
I have been selling GM and aftermarket parts over the net since 2001
the best way to contact me , is to leave a message here on .
Similar 1/4 mile timeslips to browse:
1969 Ford Mustang : 6.860 @ 204.000
Bill Sexton, Engine: 712ci Pontiac built by Sonny Leonard,
1969 Ford Mustang : 7.170 @ 177.000
CARL EPPLE, Engine: 572CI SVO 460, Tires: 33X10.5W MICKY THOMP
1969 Ford Mustang Mach 1: 7.670 @ 178.210
Phil Manquen - Walt Drakeford, Engine: 602 CI, Tires: 10.5
1987 Ford Mustang Turbo: 7.816 @ 180.800
Brad, Engine: 347CI, Turbos: Precision 98.5mm Tires: 28 x 10.5 MTs
1995 Ford Mustang Cobra: 7.889 @ 197.360
Jim Mills, Engine: 427 Windsor, Turbos: Twin GT47-88 Tires: M/T 325/50/15 Radials
2007 Ford Mustang Super GT500 Twin Turbo: 7.890 @ 175.220
EV, Engine: Built 5.4L Aluminum Engine, Turbos: Twin 67mm Precision Turbos
1989 Ford Mustang lx: 7.930 @ 172.300
jorge fretts, Engine: 598, Tires: 33x10.5w
1989 Ford Mustang LX Hatchback 10.5 tire: 8.000 @ 170.000
Marshall Hancock, Engine: 572 ci, Supercharger: n/a Turbos: n/a Tires: M/T
1986 Ford Mustang THE STAMPEEDE BANDIT: 8.013 @ 170.033
Larry Gotreaux, Engine: BBF-ELIMINATOR-460-605ci, by Tims Engines, Denham Springs,, Supercharger: N/A Turbos: N/A Tires: 27x15 GY & 33.5x17x15W-GY-D1
1993 Ford Mustang LX: 8.390 @ 167.870
Lee Howie, Engine: Bennett, Turbos: 1 Precision PT90 Tires: DOT
1987 Ford Mustang coupe: 8.400 @ 162.370
Todd, Engine: 385ci,
1989 Ford Mustang coupe: 8.420 @ 167.000
Ryan Ellington, Engine: sbc 434, Tires: mt 275/60/15 drag radial
1991 Ford Mustang GT: 8.520 @ 172.700
PRO LARRY, Engine: 351W, Supercharger: NA Turbos: NA Tires: NA
1990 Ford Mustang GT: 8.527 @ 172.300
PRO LARRY AND BRANDON G.T, Engine: 351W, Tires: 10.5 SLICK'S
1993 Ford Mustang Cobra 363 Nitrous: 8.541 @ 152.870
CJ Williams, Engine: 363,
2006 Ford Mustang GT: 8.579 @ 158.780
Paul Fercho, Engine: 572 CID big block ford, Supercharger: none Turbos: none Tires: M/T 29.5X10.5WX15 Slicks
1985 Ford Mustang lx: 8.600 @ 159.000
mike pritchard, Engine: 537ci, Tires: 30x13.50 et streets
2005 Ford Mustang GT 281 CI 80mm Turbo: 8.720 @ 155.000
Mark , Engine: 281 CI, Turbos: 80mm
1990 Ford Mustang LX Coupe: 8.780 @ 154.000
Clint Lynch, Engine: 418 windsor, Tires: 28x10.5
1991 Ford Mustang Turbo: 8.800 @ 161.000
Mike, Engine: 306CI, Turbos: Air Research 91mm Tires: 28X13.5X15 ET STREETS.