When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $89.95
Please read entire ad carefully before purchasing!
NEW FS2-HHO Edition
OBD-II Performance Chip
for
1997 Subaru SVX
L Coupe 2-Door
3.3L 3318CC H6 GAS DOHC Naturally AspiratedLSi Coupe 2-Door
3.3L 3318CC H6 GAS DOHC Naturally Aspirated
The fastest, easiest, most cost effective way to upgrade to a highly efficient & power tuned performance ECU.
What is HHO?
-
Replaces EFIE, MAP sensor enhancer, and O2 sensor modifications.
-
Compatible with factory equipped Turbo/Supercharger and Diesel Engines
-
Installs in minutes without opening the hood, no skill required
-
Compare to Jet Chip DST ($199) or Venom 400 ($349)
-
Will not void your warranty
-
Completely reversible, makes no permanent changes
-
Tuned specifically for HHO
-
Hundreds of positive reviews from HHO users and distributors
-
Lifetime Warranty
-
Satisfaction Guaranteed
*Available on our website. Standard shipping fees apply. Specifications: Hardware FS2.1-HHO Firmware Rev. 5.2 Tuning Efficiency/HHO Recommended
Fuel 87+ Interface CAN, PWM, VPW, ISO Processor 20MHz CMOS MCU Power 5-12VDC Temperature
Range -40�C to 85�C Size (MM) 80x40x15 Application: Vehicle Subaru SVX Year 1997 Engine(s) 3.3L 3318CC H6 GAS DOHC Naturally Aspirated Installation Video - HD 5:22
How it Works:
The FS2 uses an exclusive process of Dynamic Soft-Flashing not available anywhere else. Each FS2 comes programmed with a set of EPROM addresses that directly affect efficiency and performance. When the ECU attempts to read one of these addresses, the FS2 patches the factory value with one from its on-board performance tuned map. What\'s Inside:
The FS2 is based on our most powerful Dynamic Soft-Flasher, the VP12. Operating at 20MHz with plenty of Flash Memory, the FS2\'s 8-Bit CMOS microprocessor offers extended compatibility along with faster patching for safer, higher, and more consistent gains.
Will the FS2 void my warranty?
Unlike ECU ROM chip replacements or permanent ECU flashing, the FS2 makes no changes to the ROM itself and does not require opening the ECU. It will not void your factory warranty.Will it be compatible with my current modifications?
Modifications that do not alter factory compression ratio or stroke are 100% compatible with the FS2. Many upgrades such as aftermarket intake and exhaust will compliment the FS2\'s performance. The device will automatically compensate for your modifications during its initial calibration.What if I plan to add modifications later?
Anytime you add a modification that affects engine performance, you must reset the device and allow to recalibrate. During calibration the Volo Chip will extrapolate new target value sets based on your vehicle\'s current performance characteristics, fine tuning engine output.How will the FS2 affect horsepower and torque?
The FS2 will cause no loss in power. For HP and torque gains, check out the VP12 on our website.Will it work with HHO disabled?
Yes. HHO output is metered dynamically by formulation given intake air volume, fuel delivery, and O2 sensor output. The Volo Chip must be calibrated with the maximum HHO output you intend to use. The Chip can then adjust for any amount between zero up to your maximum on the fly.Will I still need an EFIE or other device?
No. The FS2 was designed to replace EFIE, MAP sensor enhancers, and O2 sensor modifications. Using these in conjunction with the Volo Chip may cause erratic gains.Why is it so much cheaper than other ECU mods?
The FS2 was purpose built and is not capable of more advanced features like altering rev limit or disabling the top speed governor.
How much can I expect to gain in my Subaru SVX?
Gains with HHO disabled will average 15-18%. Gains with HHO enabled will vary greatly depending on many factors.
Lifetime Warranty
Installation time : 10-20 minutesTools required : Screwdriver, PliersThe FS2 does NOT include an OBD-II connector, but connects directly to the OBD-II port\'s data input/output via four tap-in connectors. Most OBD-II scantools will not interfere with operation.You must press the RESET button and allow the engine to idle 1-3 minutes to calibrate the device after first installation or after modifications. Frequent installation and removal of the device is not recommended.
View full installation instructions here...
FREE 2-3 day shipping to the USA!Orders inside the USA are sent via USPS Priority Mail.International Shipping Options :
$13.45USD for 10-16 business day delivery via USPS Priority Mail International (Uninsured)
$28.95USD for 3-5 business day delivery via USPS Express Mail International (Insured)
$48.00USD for 1-3 business day delivery via DHL Express (Insured)
This product comes with a 90 day satisfaction guarantee!Please contact us before leaving NEUTRAL or NEGATIVE FEEDBACK. Doing so will not expedite refunds or communication, and solves nothing. Keep in mind that a successful transaction and your complete satisfaction is our #1 goal!In the rare event you don\'t notice a difference immediately, please reset the chip as indicated in the instructions and try again. Depending on the vehicle, it may take up to 120 miles of driving before some ECUs will accept the FS2\'s patched values. This safety feature prevents an ECU hiccup from impairing the entire system.
If you\'ve tried everything and still don\'t notice a difference, return the chip and we\'ll be glad to provide a full refund of the purchase price.
sales@voloperformance.com
Powered by eBay Turbo Lister
The free listing tool. List your items fast and easy and manage your active items.